PG7000 Ver 1.05f Embedded Software

TITLE

VER

USE WITH

PG7000™

1.05f

PG7102, PG7302 or PG7601

Instructions:
Download the file. Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC. Use a null modem cable to COM2 port of PG7000 Piston Gauge. Use a standard RS232 cable to COM1 port of PPC, PPC, RPM and molbox.

The updating of embedded software should only be performed after given specific instructions to do so from a Fluke Calibration Authorized Service Center. If the update isn't performed properly, your product will be inoperable until it is.

Updates Include:
1.05f
ADD	Support for auto-float targets < 3 psia VAC.
FIX	Allow recovery from autofloat overshoots that could stop the autofloat execution.
1.05d
CHG	Corrected calculation of piston fall rate.
1.05c
ADD	Increase # of PCs from 3 to 18.
ADD	Cal & temp coefficient fields & remote command.
ADD	Application of the temp coefficient.
ADD	Corrected calculation of piston fall rate.
CHG	Change max # of masses in a mass group from 10 to 99.
CHG	Gauge PG label from 7202 to 7102.
1.05b
ADD	New motor control power speed tables for new style board. Eliminate the DIP switch setting for motor type. Use this switch to ID new style boards.
ADD	A check for the serial # and query the user if it has been set yet.
ADD	Factory reset entry screen & menu function for discrete facory resets (DIAG only).
ADD	TEST selection to the DIAG menu to execute the COMx & IEEE production tests.
CHG	The opening credits to show correct model (PG7601, PG7102 or PG7302).
CHG	The platter rotation ready criteria from 45 to 30 rpm for the PGG & PGO.
FIX	AIR medium z calculation error. Reset the AutoFloat factory settings when the PG is initialized.

Revisionsnr.:

1.05f

||||

AU - German (Deutsch) [Change]

PG7000 Ver 1.05f Embedded Software

Secondary menu